Setting The Sensitivity; Starting Setup Mode; Starting Automatic Mode - Dometic GROUP Waeco MagicSpeed MS880 Manual De Diagnóstico

MagicSpeed MS880
3

Setting the sensitivity

3.1

Starting setup mode

NOTE
I
 To begin one of the adjusting and teach modes you must always
carry out the following procedure.
 For automatic mode (page 19), you first have to start the motor.
 For any of the other modes, you first simply have to switch the
ignition off and on again.
To start setup mode, proceed as follows:
➤ Depending on the mode, do one of the following:
– For automatic mode: start the motor.
– For the other modes: switch the ignition off and on again.
➤ Press the ON/OFF button on the control element.
➤ Apply the brake within one minute and hold it down.
➤ Press the setup button four times in rapid succession.
➤ Release the brake.
✓ You will hear four acoustic signals.
✓ You are now in setup mode and can set the cruise control.
3.2

Starting automatic mode

In automatic mode, the PPM and GAIN parameters are automatically syn-
chronised with your vehicle. You can still fine-tune both parameters anytime.
➤ Start setup mode ("Starting setup mode" on page 19).
➤ Apply the brake and hold it down.
➤ Press the RES button twice.
✓ You will hear two low-pitched signals.
➤ Release the brake.
✓ You will hear two high-pitched signals.
EN
Setting the sensitivity
19