Operating Instructions
The dehumidifier will turn off automatically when the bucket is full,
or when the bucket is removed or not replaced in the proper
position.
The bucket must be replaced in the proper position for the
dehumidifier to work. The light will be on and the
dehumidifier will not run if the bucket is not in the proper
position.
1.
Empty the bucket manually.
When the bucket is full, pull out by
grasping the handle and empty it
into a large sink or tub and then
replace it properly.
II?t;TIT, FJ Do not removewhile
operatingthe dehumidifier.
It can causewater to dropon the
base panor the floor.
Emptythe bucketwhen the indicator
lightturns on.
II?t;TIT, FJ It is advisableto carry the
bucketby supportingit from the
bottomas well as by the handle.
Carryingby onlythe handlemay
causethe handleor bucketcoverto
break.
Water level
control switch
2.
Attach a length of garden hose to the threaded drain hose
connection to carry water to the drain.
1. Remove the drain-hole cover.
When being attached to hose
connector drain hose connection,
2. Connect a garden hose to the
do not bend or kink the hose.
threaded drain hose connector.
3. Push hose connector tightly to
the drain-hole on Rear Grille.
The hoseattachmentwill
accept a standardgardenhose
fitting.
Donot over tightenthe hosewhen
connectingit to the hoseconnector,
use a rubberwasher andtightenby
handfirmly withoutstrippingthe
plasticthreads.
The hose should lie flat from the
dehumidifier to the drain.
DRAIN HOLE COVER
TAKE OUT
HOSE-CONNECTOR
12 Dehumidifier