Sony Trinitron PVM-14M2MDJ Instrucciones De Uso página 26

Location and Function of Parts and Controls
!™ > (+)/ . (–) buttons
Press to move the cursor ( z) or adjust selected value in
the menus.
!£ OVERSCAN button
Press (light on) for overscanning. The display size is
extended by approximately 20% so that the center of
screen is easier to watch. By pressing the button again,
the display returns to the normal size (light off).
!¢ UNDERSCAN button
Press (light on) for underscanning. The display size is
reduced by approximately 5% so that four corners of the
raster are visible. By pressing the button again, the
display returns to the normal size (light off).
!∞ RESET button
During menu adjustments, press to reset the setting in
the menu.
!§ DEGAUSS button
Press this button momentarily. The screen will be
demagnetized.
Wait for 10 minutes or more before activating this
button again.
Note
The picture rolls vertically while the screen is being
demagnetized.
!¶ LINE A/B select buttons
Press to select a signal (light on).
A: Press to monitor the signal fed through the LINE A
input connectors.
B: Press to monitor the signal fed through the LINE B
input connectors.
!• RGB/COMPONENT A/B select buttons
Press to select a signal (light on).
A: Press to monitor the signal fed through the RGB/
COMPONENT A input connectors.
B: Press to monitor the signal fed through the RGB/
COMPONENT B input connectors.
!ª SPLIT button
When you select RGB signals fed through the RGB/
COMPONENT A and RGB/COMPONENT B input
connectors, press this button (light on) to split the
display into two parts (upper and lower), and monitor
the both RGB signals simultaneously.
Note
Make sure the signals fed through the RGB/
COMPONENT A and RGB/COMPONENT B input
connectors are synchronized.
26
c