Help In The Event Of Faults - Hupfer KO/50-50 Manual De Instrucciones

Help in the event of faults

Service work should only be carried out by authorised specialist staff.
Defective components should only be replaced with original parts.
Please check first of all whether there has been an operating error. You yourself can eliminate some faults.
In the event of after-sales service and when ordering replacement parts give the data set out in the identifi-
cation plate (see page 19).
Fault
Appliance does not become
warm,
indicator light does not come
on.
Appliance becomes warm, indicator light does not come
on.
Regular inspection and maintenance of the appliance prevent disruptions to operation and ensure safety.
Inspection and maintenance intervals depend upon the use of the appliance. Consult your dealer's after-sales
service department.
30
agents should be used in any case.
After each cleaning operation remove all cleaning agent residues by rinsing
with copious fresh water. Afterwards the surface should be thoroughly dried.
Do not bring parts made from stainless steel into contact with concentrated ac-
ids, seasonings, salts etc. for longer than is absolutely necessary. Acid fumes
which form during cleaning of tiles also promote the corrosion of "refined stain-
less steel".
Avoid damaging the surface of the stainless steel, particularly by metals other
than stainless steel. Residues of extraneous metals produce extremely small
amounts of chemical elements which can cause corrosion. In any case, con-
tact with iron and steel should be avoided because that leads to extraneous
rust. If stainless steel comes into contact with iron (steel wool, swarf from
pipes, water containing iron), this can be the trigger for corrosion. Therefore
for mechanical cleaning use exclusively refined steel wool or brushes with nat-
ural, plastics or refined steel bristles. Steel wool or brushes with unalloyed
steel lead to extraneous rust due to abrasion. Fresh rust sites can be eliminat-
ed using gentle abrasives or fine abrasive paper. More severe rust sites can
be washed away with warm 2 – 3 % oxalic acid solution. If these cleaning
agents fail, treatment with 10 % nitric acid is necessary.
Caution! This should only be carried out by technically trained staff observing
the existing regulations!
Possible cause
Defective fuse at the building
end.
ON/OFF switch defective.
Mains connection cable or
mains plug defective.
Indicator light defective.
Circuit defective.
Action
Check fuse and repair if need be.
Disconnect appliance from the mains and
have it checked and repaired if need be by
authorised specialist staff.
Take appliance out of operation and have it checked and repaired if need be by author-
ised specialist staff.
Solid basket stackers
43.3000.7