Testing Individual Devices; Testing Individual Wireless Keys; Mount The Rf5132 And Wireless Devices - DSC RF5132-433 Manual De Instrucciones

Read the test results at the keypad:
Result LED Keypad
Good Light 1 On Steady
Bad Light 3 On Steady
Activate the device until you get 3 'good' results in a row.
You may mount the WLS devices where results were good.
Devices indicating a bad result must be moved to another location. You may only have to move the device a few
inches to correct a bad result.
Do not mount any device where a "bad" test result was indicated.
7. Go to the next device to be tested and activate it until the test result is displayed/sounded.
Wait until the placement test of one device is shown/sounded before beginning to test the next device.
NOTE:
Continue to test the devices until both the RF5132 and the devices are in good locations. If several wireless
devices produce 'bad' test results, you may need to move the RF5132 to a better location (see section 2.2 for tips
on finding a location for the RF5132).
8. To exit the placement test and return to installer programming, press [#] twice.

Testing Individual Devices:

1. Temporarily place the device where you want to mount it.
2. At a system keypad, enter [*][8][Installer Code].
3. Enter programming section [904].
4. Ensure option 8 in section [90] is disabled.
5. Enter the 2-digit zone number for the device to be tested.
6. Activate the device being tested until a result is displayed on the keypad or sounded by the keypad or bell.
(Same as step 5 in the Global Placement Test section, previous page).
7. To test another device, press [#] once, then repeat steps 4 - 5. Continue to test the devices until both the
RF5132 and the devices are in good locations.
If several wireless devices produce 'bad' test results, you may need to move the RF5132 to a better location (see
section 2.2 for tips on finding a location for the RF5132).
8. To exit the placement test and installer programming, press [#] twice.

Testing Individual Wireless Keys:

Do not use the individual device test described above to test the wireless keys. To ensure that the RF5132 receiver is
receiving transmissions from these devices, use the function keys on these devices at several different points in the
installation.

5.2 Mount the RF5132 and Wireless Devices

When you have tested reception of the RF5132 with all the wireless devices (see section 5.1) and you have a good
mounting location, mount the RF5132:
1. Pull the Keybus wires through the hole at the bottom of the cabinet.
2. Mount the cabinet securely to the wall.
LCD Keypad Buzzer/Bell
"Good" 1 Beep/Squawk
"Bad" 3 Beeps/Squawks
13