EdilKamin FANTASY Instrucciones De Uso página 38

MIMIC PANEL
hold down for 2 seconds to turn stove on or off
Pressed brie y it switches the stove from manual to automatic operating mode; held down (pressed and held for 2")
it gives access to the various programming menus.
increases the various settings
decreases the various settings
Each time it is pressed tells the electronic circuit board memory that 15Kg have been loaded into the tank; pressing it
continuously for 5" cancels any residual or previously loaded Kg.
Pressed brie y it switches the stove's fan from the quieter "Comfort" level to the higher energy "Turbo" level.
1 2 3 4
Loading the feed screw.
Should the pellet hopper empty completely the feed screw
must be lled. To do so, keep the + and – keys pressed simul-
taneously for a few seconds (on the remote control or synoptic
panel). Once released, 'REFILL' will appear on the display.
This must be carried out before ignition if the stove has stopped
due to the pellets having nished.
It is quite normal for some pellet residue to remain inside the
hopper, this is what the feed screw is unable to pick up.
Once a month, fully vacuum the hopper to prevent dusty resi-
due from accumulating.
Automatic ignition
With the stove on standby, press the 0/1 button for 2 seconds
(on the synoptic panel or remote control). This will startup
the ignition process, 'Start-up' will appear on the display and
a countdown will commence in seconds (1020). There is no
preset time for the ignition process: its duration will be automa-
tically shortened if the control board detects that certain tests
have been carried out positively. The ame appears after about
5 minutes.
INSTRUCTIONS FOR USE
"Touch in correspondence to the LED points to select the desired operating power.
Alternatively, the traditional setting can be used, which can be selected using the +/- buttons."
5
Manual ignition
At a temperature lower than 3 °C – too low for the electrical
resistance to become red hot - or if the resistance is temporarily
not working, you can use a relighter to ignite the stove.
Insert a well-lit relighter into the combustion chamber, close
the door and press 0/1 on the synoptic panel or remote control.
Operating modes Manual: the user sets the desired operating power (from
a minimum of 1 to a maximum of 5)
Automatic: the user sets the desired room temperature
using the +/- key or the remote control, the stove reads the
setting and adjusts the power to reach the temperature set,
then sets itself to Power 1.
Manual mode from synoptic panel/remote control
With the stove in operation mode or on standby, press and
release the MENU button on the synoptic panel/remote
control and 'Power' will appear on the display (showing
the power at which the stove is working). Press the + key on
the remote control to increase the operating power (from Power
1 to Power 5). Setting the fan via the Synoptic Panel
With the stove in operation mode or on standby, rotate the
right knob to adjust the ventilation setting (from 1 to 10 in
all powers).
- 38
-