Facom NU-CL.CV/1005 Manual De Instrucciones página 13

Using the machine:
- Apply the safety instructions provided in this manual.
- Fitting the bit or the bit holder onto the screwdriver:
- Pull the knurled ring (mark 5) forward and engage the bit.
- Check the bit or bit holder is locked on the machine by pulling it.
- Fitting the socket on the nutrunner:
- Engage the socket fully on the drive square (mark 6).
- Check it is maintained properly by pulling it.
- Select the rotation direction (selector mark 2).
- To start, press the trigger (mark 1) gradually.
The variator allows for increasing the rotation speed according to the pressure on the trigger.
For safety reasons, the chuck is stopped when the trigger is released.
- To improve visibility, you can switch on the built-in LED light (button mark 3).
Do not forget to switch off the LED light after use (power consumption).
Do not change the speed, rotation direction, or screwing torque while the motor is running.
Recommendations of use:
Accessories:
- Only use accessories adapted to the task at hand and to the machine used (impact grade sockets and bits) ; your safety, the
quality of your work and the tools lifetime depend on it.
The FACOM range includes a range of impact bits, bit holders and sockets suited to your needs (see <<FACOM accessories>>
section).
Screwing:
These machines are no substitutes for torque wrenches (the max torques are approximate). For high quality screwing, use the
machine for the approach work, and complete tightening by hand or using a torque wrench.
CAUTION ! the machine's power is likely to damage a screw offering insufficient resistance (e.g. wheel nuts...)
Storage:
We recommend storing your power tools in a dry and temperate location (temperature above 5˚C and below 40˚C) ; your
batteries will provide more power.
Heavy use:
- In case of heavy use, allow the machine to cool down a few minutes between each use.
A heat sensor protects the machine by automatically cutting the power supply in case of overheating.
Maintenance:
- Clean the machine with a clean and dry cloth. Do not lubricate. Do not open or dismantle the machine.
- Avoid shock and dropping which will damage the machine; after a shock or a drop, check that the controls operate normally,
that the tool has no run out nor unusual vibration, that the covers have no play, are not cracked nor dented, and that the battery
is properly fastened.
In case of abnormal operation: call your FACOM distributor.
Changing the carbon brushes (CL.C1913D)
If you notice a drop in your tool's level of performance, check the condition
of the motor brushes. If required, replace them, as follows:
1) remove the tool's battery to prevent any risk of electrical shock.
2) unscrew the cover protecting the brush (figure 1)
3) remove the used brush (figure 2)
4) fit a new carbon brush instead of the used one (figure 3)
5) screw the protection cover back (figure 4)
6) repeat steps 2 to 5 for the second brush.
To guarantee optimum operation of your tool:
- always replace the 2 carbon brushes simultaneously
- only use FACOM recommended carbon brushes (CL.CBN1)
NU-CL.CV_1005 13
5
2
CL.V146D
6
2
CL.C1913D
1
3
18/11/05, 9:17
2
4