Charging The Batteries - Facom NU-CL.CV/1005 Manual De Instrucciones

Intended use of the machines :
- The CL.V146D and CL.C1913D screwdrivers and nutrunners are designed to screw and unscrew screws and nuts.

Charging the batteries :

Your new batteries will reach their full capacity only after about 3 ''charge-discharge '' cycles.
Charging the battery:
- Press the release buttons (mark 7) on the battery to release it from the machine.
- Slide the battery to the front of the machine.
- Connect the charger to mains (230 V ~).
1
When you plug the charger, the
green indicator blinks, and a
sound alarm buzzes.
- Disconnect the charger.
- Press the release buttons (mark 7) on the battery and slide it to pull it out from the charger.
- Re-engage the battery firmly onto the machine.
Universal charger :
- Your charger can be used to charge different FACOM batteries, from 9.6 to 19.2 Volts, whether Ni-MH or Ni-Cd.
Charging conditions:
- To ensure the most effective charging, the battery charger has a temperature sensor (NTC) authorising charging between 10˚C
and 40˚C.
- If the battery has been stored at a temperature below 5˚C, allow it to warm up to room temperature before charging it.
- If a battery is too hot after prolonged use, allow it to cool down for a few minutes before charging it.
Ni-MH batteries :
- FACOM Ni-MH batteries have no ''memory effect''; therefore you do not need to empty them completely before recharging them.
RECOMMENDATION: To prolong battery life and increase performance, completely discharge them once or twice a year, by
running the machine with no load until the motor comes to a complete standstill.
After charging : After charging :
After charging : After charging : After charging :
- The Facom CL.CH919 charger allows leaving the battery in place after charging without damaging it; a maintenance current
replaces the charging current when the green indicator is lit.
However, we recommend removing the battery once it is charged.
NU-CL.CV_1005
2
Fully push the battery onto the charger
by sliding it in the direction shown by
the arrow. The battery contact
protection device will automatically
retract.
The battery is
charging,
the red indicator
is lit.
The charger is waiting as the
battery temperature is not
adapted to the charge, the
red indicator blinks, 2 beeps
are emitted
12
3
The battery is charged properly.
The green indicator is lit, 5 beeps
are emitted.
If the 2 indicators blink and
about twenty beeps emitted:
- the battery either does not
comply or is faulty,
- or the charger is faulty.
Contact your retailer
18/11/05, 9:17