Hitachi C 10FL Manual De Instrucciones página 17

INSTALLING THE TABLE INSERT (Fig. N)
The table insert has been previously installed on your
unit. However, you must verify that the table insert is
flush with the table top surface on all four corners of the
insert.
If the table insert is not flush with the table, adjust the four
bolts (1) with a 4mm hex. wrench until it is parallel with
the table.
Note: To raise the insert, turn the hex screws
counterclockwise, to lower the insert, turn the hex screws
clockwise.
Fig. N
1
STORAGE (Fig. O, P)
Rip fence and miter gauge (Fig. O)
Storage brackets for the rip fence (2) and miter gauge (1)
are located on the right side of the saw housing and frame
of leg.
Fig. O
1
2
— 17
Power Cord (Fig. P)
For convenience and to prevent damage to the power
cord when the table saw is not in use or is being
transported, the frame of leg has two brackets (1) on the
side for cord atorage.
Fig. P
1
MITRE GAUGE ADJUSTMENT (Fig. Q)
1. Make sure that the mitre gauge bar (1) will slide freely
through the table top grooves.
2. Loosen the lock knob handle (2) and turn the gauge
body (3) to set the pointer (4) at 0 on the scale.
3. Make a 90 cut in a scrap piece of wood. Check the cut
to see if it is 90. If not, loosen the lock knob handle (2)
and move the mitre gauge body until it is square to the
miter gauge bar by using a combination square.
MITRE GAUGE OPERATION (Fig. Q)
The mitre gage is accurately construted with index stops
at 0 , 15 , 30 , 45 , 60 both right and left side.
The operate the mitre gage, simply loosen the lock handle
(2) and move the body of the mitre gauge to the desired
angle. The mitre gauge body will stop at 0 , 15 , 30 , 45 ,
60 both right and left side.
Fig. Q
—
English
1
3
2
4