BVA Hydraulics HL1001 Manual De Instrucciones página 3

Failure to comply with the following warnings may
result in personal injury as well as property damage.
Study, understand, and follow all instructions
provided with and on this device before use.
The user must be a qualified operator familiar
with the correct operation, maintenance, and use
of cylinders.
Wear protective gear when operating
operating hydraulic equipment.
This device is NOT suitable for use as support
device! As the load is lifting, use blocking and
cribbing to guard against a falling load. Stay clear
of a lifted load before it is properly supported.
Never rely on hydraulic pressure to support a load.
Crush Hazard. ep hands and feet away
f r o m c y l i n d e r a n d w o r k p i e c e d u r i n g
operation.
Do not exceed rated capacity of the cylinder or
any equipment in the system. The cylinder is
designed for a max. pressure of 10,000 psi.
Do not connect a cylinder to a pump with higher
pressure rating.
suddenly, causing the system pressure to exceed rated
pressure.
The system operating pressure must not exceed
the pressure rating of the lowest rated component
the system. install a pressure gauge or other load
measuring instrument to monitor the operating
pressure. Burst hazard exists if hose, connection or any
other component in the system exceed its rated pressure.
Avoid damaging hydraulic hose. Do not allow hose
to kink, twist, curl, crush, cut or bend so tightly
that fluid flow within the hose is blocked or reduced.
Periodically inspect the hose for wear.
Inspect before each use. Do not use if leaking, broken, bent, cracked or otherwise damaged parts
dropped suddenly, unexpectedly upon it), discontinue use until checked out by a BVA Hydraulics
authorized service center. Owners and operators of this equipment shall be aware that the use and
subsequent repair of this equipment may require special training and knowledge. It is recommended
decals, warning / safety labels or signs be replaced with BVA Hydraulics authorized replacement
parts only. Any cylinder that appears to be damaged in any way, is worn or operates abnormally
sall be removed from service immediately until such time as repairs can be made.
WARNING
!
fully engaged into/onto adapters, extension accessories.
service center.
3
Do not pull, position or move cylinder setup by
host. Use carrying handle or other means of
safe transport.
Do not handle pressurized hoses. Never attempt
to grasp a leaking pressurized hose. Ensure to
release the sytem pressure before disconnecting
hydraulic hose or connections.
Hydraulic fluid can ignite and burn. Keep hydraulic
equipment away from flames and heat. Excessive
heat will soften seals, resulting in fluid leaks. Heat
also weakens hose materials.
Cylinder must be on a stable base which is able
to support the load while pushing or lifting. Use
shims, friction material or constrains to prevent
slippage of the base or load. Ensure cylinder is
Center load on cylinder. Distribute load evenly
a c r o s s t h e e n t i r e s a d d l e s u r f a c e . D o n o t
off-center loads on a cylinder. The load can tip
or the cylinder can "kick out".
Never try to disassemble a hydraulic cylinder,
refer repairs to qualified, authorized personal.
Contact BVA hydraulics Tech Service for authorized
impact.
Hose material or seals must not come in contact
with corrosive materials such as battery acid,
Never paint a coupler or hose.
Use only factory authorized fasteners, accessories
and hydraulic fluid.