Gira 5490 Serie Manual De Instrucciones página 6

Módulo de superficie inalámbrico de 1 elemento para conmutación o regu­
lación
Switch-on brightness
Minimum brightness
Maximum brightness
Dimming adjustment time
Switch-on delay
Switch-off delay
32582722 10864994
1...100 %
Basic setting: 100 %
1...67 %
Basic setting: 5 %
75...100 %
Basic setting: 100 %
1...60 s
Basic setting: 4 s
0 s ... 24 h
Basic setting: 0 s
0 s ... 24 h
Basic setting: 0 s
27.04.2017
During brief operation, the out-
put switches on at the set
switch-on brightness.
Note: If the value is above the
set maximum brightness or
below the minimum bright-
ness, then the system will
switch to the appropriate limit
value.
Specifies the minimum setta-
ble brightness.
Note: If parameters or scene
values are set to a level lower
than the minimum brightness,
then the system will dim to mi-
nimum brightness.
Specifies the maximum setta-
ble brightness.
Note: If parameters or scene
values are set to a level higher
than the maximum brightness,
then the system will dim to
maximum brightness.
Time from minimum bright-
ness until reaching maximum
brightness (dimming speed).
The load switches on after a
delay. Repeated switch-on
commands restart the delay ti-
me. If the load has not yet
been switched on due to the
delay when a switch-off com-
mand comes, then the load
will remain off.
Note: The set time apply to
operation using radio transmit-
ters. The device is switched
immediately when the Prog
button is pressed.
The load switches off after a
delay. Repeated switch-off
commands restart the delay ti-
me. If the load has not yet
been switched off due to the
delay when a switch-on com-
mand comes, then the load
will remain on.
Note: The set time apply to
operation using radio transmit-
ters. The device is switched
immediately when the Prog
button is pressed.
6/15