Gira 5490 Serie Manual De Instrucciones página 12

Módulo de superficie inalámbrico de 1 elemento para conmutación o regu­
lación
Manual switch-off of the run-
on time
Operating hours
Extended channel settings "switching"
Parameters
Operating mode
Manual commissioning
Local Operation
Behaviour on voltage return
Behaviour after the end of the
disabling function
Manual saving of the scene
values
32582722 10864994
On, Off
Basic setting: Off
0...65535
Basic setting: Current value
Setting options, Basic set­
ting
Normal operation
Continuous on
Continuous off
Basic setting: Normal Opera-
tion
On, Off
Basic setting: On
On, Off
Basic setting: On
On
Off
Last value
Basic setting: Off
On
Off
no change
Last value
Basic setting: No change
On, Off
Basic setting: On
27.04.2017
Allows manual switch-off of a
running run-on time. If the pa-
rameter is switched off, then a
switch-off command will also
switch the actuator on. Only
visible if a run-on time was
set.
The time is counted during
which the load is physically
switched on.
This parameter can be reset to
"0", for example after exchan-
ging the load.
The Reset button is used to
reset the meter to "0". The de-
vice must be programmed to
apply the change.
Explanations
see Device and channels
Blocks manual commissioning
for the device channel.
Note: In the "Off" setting, the
device cannot be reset to the
factory setting.
Blocks the output for operation
using the Prog button.
Defines the behaviour of the
output after voltage return.
Behaviour of the output when
a block is removed.
Disables the saving of the cu-
rrent brightness value as sce-
ne value in an actuator for a
command via a transmitter.
12/15