Monacor hifi MKA-60/WS Manual De Instrucciones página 7

2) At the jacks OUTPUT (4) the fed-through signal of
the respective input jack (5) is available: the signal
of the XLR input at the XLR output (balanced) and
the signal of the phono input at the phono output.
Here it is possible to connect e. g. the input of an-
other active speaker system. The output signal is
independent of the volume control (1) and the tone
controls (2) and (3).
3) Finally connect the mains cable (6) to a socket
(230 V~/50 Hz).
4.3 Operation
CAUTION Never adjust a very high volume. Perma-
nent high volumes may damage your
hearing! The human ear will get accus-
tomed to high volumes which do not
seem to be that high any more after some
time. Therefore, do not further increase a
high volume after getting used to it.
1) Switch on the connected signal source.
2) To prevent switching noise, turn the control
VOLUME (1) to MIN prior to switching on. Then
switch on the active speaker system with the mains
switch POWER (9). The POWER LED (8) lights up.
3) Adjust the desired volume with the VOLUME con-
trol (1).
4) Adjust the sound with the two controls LOW (2) and
HIGH (3) in an optimum way.
5) After the operation switch off the unit with the
POWER switch (9).
5 Specifications
Model
2-way system
Frequency range
Amplifier power
Inputs
Sensitivity
Impedance
SPL
SPL (1 W/1 m)
max. rated sound pressure
Ambient temperature
Power supply
Power consumption
Dimensions (W x H x D), weight
Subject to technical modification.
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
MKA-60/SW
MKA-60/WS
1
16 cm (6 /
2
and dome tweeter
45 – 20 000 Hz
15 W
25 W
89 dB
100 dB
40 VA
220 x 293 x 170 mm, 4.2 kg
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
") bass speaker
RMS
MAX
XLR (bal.), phono (unbal.)
250 mV
10 kΩ
0 – 40 °C
230 V~/50 Hz
270 x 365 x 220 mm, 6.9 kg
MKA-80/SW
MKA-80/WS
20 cm (8") bass speaker
and dome tweeter
35 – 20 000 Hz
20 W
RMS
30 W
MAX
89 dB
102 dB
50 VA
GB
7