Tritec TRI-KA Instrucciones De Manejo página 239

Error messages and possible solutions_239
Remedy
Insert SD card
Replace SD card
Replace MMC card with SD card
Switch off the device immediately! Check the measuring setup!
Switch off the device immediately! Check the measuring setup!
Contact TRITEC!
Contact TRITEC!
Connect a module or string to the measuring device
Check the measuring setup!
Observe the polarity of the communication lines
Repeat the measurement with higher irradiation!
Check the position of the irradiation sensor TRI-SEN!
Repeat the measurement with constant irradiation
Check the position of the irradiation sensor TRI-SEN!
STC extrapolation is not performed with thin-layer modules!
Synchronise measured TRI-SEN data under menu item "Memory"
Repeat measurement
Position TRI-KA and TRI-SEN within radio range
Repeat measurement
Repeat measurement
Perform Firmware update on measuring device
Delete measurement file in PC software
Perform Firmware update on measuring device
Delete file
Charge measuring devices using the supplied charger
Firmware file Vx_x_x.TFW must be in directory x:\TRI-KA\UPDATE
Firmware file Vx_x_x.TFW must be in directory x:\TRI-KA\UPDATE
Copy new Firmware file Vx_x_x.TFW into directory x:\TRI-KA\UPDATE
Insert SD/SDHC card into the TRI-KA
Use new SD/SDHC card
Perform measurement using the Dummy module "TRITEC" and add missing module to the PC software in
the module database
Install new module database
Inform TRITEC of update to module database