Tabla de contenido
Idiomas disponibles
Idiomas disponibles
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
2
3
► 1. Groove 2. Hook 3. Screw
OPERATION
Inspecting trigger function
CAUTION:
Make sure that the trigger function
is in working order before each operation. The
tool must not operate only by pulling the trigger
or only by placing the contact element against the
workpiece. If you find such issues, contact Makita
authorized service centers for repairs.
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
Driving nails
WARNING:
Continue to place the contact
element firmly on the material until the nail is
driven completely. Unintentional firing may cause
personal injuries.
1
CAUTION:
Do not drive nails on hard mate-
rials such as metal or the like. If the nail cannot
penetrate the material, the nailer may be kicked back
toward you and cause injury.
NOTE: If you drive nails continuously for a long time,
the exhaust air will get hot due to the heat from the
motor.
The tool employs two nailing actions: intermittent nailing
(sequential mode) and continuous/intermittent nailing
(continuous mode).
1
► 1. Switch trigger 2. Contact element 3. Mode select-
ing switch 4. Sequential mode 5. Continuous mode
Intermittent nailing (sequential mode)
1.
Set the mode selecting switch to the sequential
mode.
2.
Release the trigger lock.
3.
Place flat the contact element on the material.
4.
Pull the switch trigger fully to drive a nail.
5.
To drive the next nail, release the switch trigger
and contact element once, and then repeat the step 3
and 4 above.
WARNING:
Always be sure to first place the
contact element against the workpiece before
pulling the trigger.
Continuous/intermittent nailing
(continuous mode)
1.
Set the mode selecting switch to the continuous
mode.
2.
Release the trigger lock.
3.
Pull the switch trigger first and then place the
contact element against the workpiece.
4.
To drive the next nail, keep your finger pulling the
switch trigger and place the contact element against the
workpiece again.
9 ENGLISH
3
4
5
2
Tabla de contenido
