6 Separate Settings For The Four Receiver Sections; 6 1 Output Level Line Or Mic; 6 2 Squelch; From The Receiver - Monacor JTS R-4/5 Manual De Instrucciones

4.6 Separate settings for the four
receiver sections
The menus of the receiver sections (fig 26) can-
not only be used to select the frequency and
the channel, but also to set the output level
and the interference suppression (squelch) In
addition, the corresponding transmitters can be
most conveniently set by means of menu item
(see fig 29)
7.Mic Config
To call up the menu for a specific receiver section,
either
– press the button SEL (12) for the receiver section
desired (on the display, the field of the receiver
section is highlighted) and then keep the button
SETUP (6) pressed until the menu is shown or
– keep the button SETUP pressed until the menu
with the line
1.System Options
Use the button PUSH / CONTROL (7) to select
the receiver section CH1 – 4 and then press the
button to call up the setting menu
1.Frequency
2.Group/Channel
3.Scan
4.Squelch
5.Remoset ID
6.Output Level
7.Mic Config
4.6.1 Output level Line or Mic
The menu item
6.Output Level
to separately set each of the individual audio out-
puts to line level or microphone level
Setup Ouput Level
Line
Mic.
for connection to a line level input
Line
for connection to a microphone input
Mic
Turn the knob PUSH / CONTROL to select the
setting; then press the button SETUP to save the
setting
is shown
Fig. 26
can be used
Fig. 27
4.6.2 Squelch
The interference suppression will mute the re-
ceiver section in speech / music pauses when inter-
fering signals are received and the levels of these
signals are below an adjustable threshold value
A high threshold value, however, will reduce the
transmission range as the receiver will also be
muted when the power of the radio signal from
the transmitter falls below the threshold value
adjusted Therefore, adjust a high threshold value
when the reception is good and a low value when
there is a great distance between the transmitter
and the receiver
1) Call up the setting for interference suppression
via the menu item
Setup Squelch
+4
Low 0
2) Turn the knob PUSH / CONTROL to change
the threshold value:
0 = standard setting
1...+10 the higher the threshold value, the
lower the sensitivity to interference
signals
–1 ... –5 the lower the threshold value, the
higher the sensitivity to interference
signals
3) Press the button SETUP to save the setting
4.6.3 Making settings for the transmitters

from the receiver

To make the following settings for the trans-
mitters on the receiver, go to the menu item
:
7.Mic Config
Menu item
1.Mic.Sensitivity
2.Mic.Attenuate
(TB)
3.Mic.RF Power
4.Mic.KeyLock
5.Remoset Config
6.Return
Fig. 29 Setting options for the transmitters
:
4.Squelch
High
Fig. 28
Setting
microphone sensitivity
to reduce the sensitivity by
additional 20 dB (only pos-
sible for model R-4TBM / 5)
transmission power
10 / 50 mW
key lock on / off
to select settings for trans-
mission
to go back to
the higher-level menu
25