Pentair intellicomm Automation Guia De Instalacion página 6

6
Section 6
Conecting AC power wires to IntelliComm
WARNING! IMPORTANT SAFETY PRECAUTIONS. BEFORE STARTING READ
THE FOLLOWING: Read all the safety precautions in this manual before attempting
any electrical wiring. Be sure to read and follow all safety Instructions on page
ii. Wiring should only be performed by a qualified professional. When using
electrical products, basic precautions should always be followed, including the
following:
• Grounding is required. The unit should be installed by a qualified service person and
grounded.
To connect the AC power wires to IntelliComm:
1. Connect the main AC power wires to the IntelliComm AC terminals number 1 and 2
as shown below.
2. Grounding: Attach incoming GROUND wire to the ground terminal as shown below.
Earth grounding is necessary to ensure personal safety and safety of equipment.
3. Close the front cover and tighten the two cover screws.
Ground terminal
Attach incoming AC (100 VAC to 240 VAC 50/60 Hz)
wires to AC terminals 1 and 2