BWT PERMAQ compact 2 Instrucciones De Montaje página 40

EN
DATE / TIME
CONDUCTIVITY / TDS
OPERATION MODE
Fig. 13
LANGUAGE
OPERATING MODE
START PRESSURE
STOP PRESSURE
* PRESSURE TANK "YES"
PRESSURE TANK "NO"
* PRESSURE TANK "YES"
PRESSURE TANK "NO"
PRESSURE TANK "YES"
* PRESSURE TANK "NO"
PRESSURE TANK "YES"
* PRESSURE TANK "NO"
Note: The given setting for the adjusting
range of the pressure values is only valid
for the mode „pressure tank operation
YES".
The mode of "pressure tank OFF" is with
the „stop pressure" fixed at a value of
2.0 bar.
Fig. 14: Programming procedure: "OPERATION MODE", "STOP PRESSURE" and "FLUSH TIME" – Example scheme
40
to call up the
PASSWORD:
BACK
OPERATING MODE
START PRESSURE
STOP PRESSURE
BACK
BACK
STOP AT 2.1 bar
BACK
STOP AT 3.1 bar
BACK
BACK
Setting range:
"Stop pressure" 2.0 ... 4.0 bar "Start pressure" the value selection of
the start pressure (ON/OFF, hysteresis)
is between 0.3 ... 1.6 bar selectable
incremental steps
»
"LANGUAGE" menu point, please refer to Fig. 12
BACK
PASSWORD
_ _ _ _ _ _
Fig. 18
[+/- 0.1 bar]
« :
OPERATING MODE
START PRESSURE
STOP PRESSURE
BACK
DATE / TIME
CONDUCTIVITY / TDS
OPERATION MODE
LANGUAGE
BACK
AUTO RINSE
SERVICE
STOP DELAY
SETUP
BACK
STOP AT
60 sec
STOP AT
15 sec
Setting range: 0 ... 60 seconds
Observe: setting is deactivated at 0 sec.