Mounting The Paint Hopper; Attaching The Return Tube; Priming The Pump - Titan ED655 Manual Del Propietário

Mounting the Paint Hopper

1. Align the bottom of the paint hopper with the threaded inlet
valve on the paint pump block.
2. Turn the paint hopper clockwise to thread it onto the inlet
valve. Continue to turn the paint hopper until it is secure on
the inlet valve.
NOTE: Make sure the threads are straight and the hopper
turns freely on the inlet valve. Do not cross-thread.
3. Place the filter screen into the bottom of the paint hopper and
snap it in position.

attaching the return Tube

1. Make sure that the motor switch is turned to OFF.
2. Screw the return tube fitting found in the literature set into
the return tube port on the side of the pump.
NOTE: Do not over-tighten. Hand-tighten only. Some
threads will be visible even when fully tightened.
3. Place the straight end of the return tube into the return tube
fitting.
Return Tube Fitting
Return Tube
4. Thread the nut on the return tube onto the return tube fitting
and tighten until the return tube is secure.
5. Place the hook end of the return tube into the hole in the
paint hopper cover.
Paint Hopper Cover
English

Priming the Pump

1. Turn the pressure control knob counterclockwise to its lowest
pressure setting.
Pressure Control Knob
2. Remove the paint hopper cover and fill the paint hopper with
material.
3. Turn the PRIME/SPRAY knob to PRIME.
4. Turn the motor switch to ON.
5. Turn the pressure control knob clockwise to between half and
full pressure. Let the unit prime 1 to 2 minutes after material
begins to flow through the return tube.
IMPOrTaNT: always reduce the pressure to zero before
changing the position of the PrIME/SPray knob. Failure to do so
may cause damage to the paint pump diaphragm.
IMPOrTaNT: If the pressure control knob is reduced to zero
and the PrIME/SPray knob is still on SPray while the sprayer is
operating, there will be high pressure in the hose and spray gun
until the PrIME/SPray knob is turned to PrIME or until the spray
gun is triggered to relieve the pressure.
Return Tube
6
PRIME/SPRAY Knob
© Titan Tool. All rights reserved.