Operation Controls - GBC Ricoh StreamPunch Pro Manual De Instrucciones

3. OPERATION CONTROLS

A. On/Off Switch "I/O"
Must be in the "ON" position at all times
B. Chip Tray:
Easy-to-access chip tray for quick chip disposal
C. Die Set Changes:
Are completed without tools and only take seconds to perform
D. Die Set Storage:
Holds up to 3 spare Die Sets
E. Punch Bypass:
Short straight-through paper path for unpunched documents
F. Punch Mode Path:
Wide radius turn can support stocks up to 216 g/m
G. LED Indicators:
Inform operator that power is on, punch is enabled, chip tray is full or
out, die-set is not properly seated, door is open, or there is a paper
jam.
4. PUNCHING PATTERNS
The StreamPunch uses a variety of easily interchangeable die sets
that allow you to punch documents in line for several different binding
styles. By selecting the appropriate die set, you can use your
StreamPunch to punch documents in any of the binding styles indicated
in Table 1.
For Plastic Comb Binding choose from:
1
PB Plastic Bind; Hole Size: 8mm x 2.9mm (0.313" x 0.116") (LxW); Center-to-Center Hole Spacing: 14.3 mm (0.563")
For Twin Loop™ Binding choose from:
1
W3 Wire; Round; 3 Holes per inch; Hole Size: 4mm x 4mm (0.156" x 0.156") ( L x W); Center-to-Center Hole Spacing: 8.5mm (0.333")
1
W2 Wire; Round; 2 Holes per inch; Hole Size: 6.4mm x 5.4mm (0.250" x 0.214") (L x W); Center-to-Center Hole Spacing:
12.7 mm (0.500")
For Color Coil™ Binding choose from:
1
C4 Coil; Round; 4 Holes per inch; Hole Size: 4.4mm ( 0.147") Diameter; Center-to-Center Hole Spacing: 6.3mm (0.2475")
For Velo ® Bind choose from:
1
®
VB Velobind ; Round; 1 Hole per inch Hole Size: 3.2mm ( 0.125") Diameter; Center-to-Center Hole Spacing: 25.4mm (1")
For Looseleaf Binding choose from:
1
4 Ring Binder; U.S. (Standard Looseleaf Patterns); Hole Size: 8mm (0.316") Diameter
For Proclick ® Binding choose from:
1
®
Proclick ; Rectangle; Hole Size: 4.9mm x 5.5mm; 0.196"x0.215" (LxW); Center-to-Center Hole Spacing:8.5mm(0.333")
Paper Weight: 75gsm to 200gsm (20lb Bond to 110lb Index)
©2003 GBC, Northbrook Illinois - All rights reserved. Rev 10/02 R2 3/03
StreamPunch
2 cover
21
34
23
47
12
4
34
Graphics do not represent actual punch pattern dimensions or spacing.
Pro, Pro EX & MP
TM
Please note that each punching style listed above requires
a separate die set for the StreamPunch. The StreamPunch
can hold up to four Die Sets in it's cabinet (one in the
operating slot and three in the storage area).
To purchase additional or replacement Die Sets, contact
your authorized sales representative.
GB
5