Maintenance And Cleaning - TECshow BEAMPIX 14 Manual De Usuario

7. MAINTENANCE AND CLEANING

The following points have to be the considered
during the inspection:
1. All screws for installing the devices or parts of
the device have to be tightly connected and
must not be corroded.
2. There must not be any deformations on the
housing, color lenses, fixations and installation
spots(ceiling, suspension, trussing).
3. Mechanically moved parts must not slow any
traces of wearing and must not rotate with
unbalances.
4. The electric power supply cables must not
show any damage, material fatigue or sedi-
ments.
Further instructions depending on the installation
spot and usage have to be adhered by a skilled
installer and any safety problems have to be re-
moved.
Caution: Disconnect from mains before starting
maintenance operation.
In order to make the lights in good condition and
extend the life time. We suggest a regular cleaning
to the lights
1. Clean the inside and outside lens each week to
avoid the weakness of the lights due to accu-
mulation of dust.
2. Clean the fan each week.
3. A detailed electric check by approved electrical
engineer each three month, make sure that the
circuit contacts are in good condition, prevent
the poor contact of circuit from overheating.
Design and product specifications are subject to change without prior notice.
P. 10
Tecshow Beampix 14 |
English version
We recommend a frequent cleaning of the device.
Please use a moist, lint-free cloth. Never use alco-
hol or solvents.
There are no serviceable parts inside the device.
Please refer to the instructions under "Installation
Instructions". Should you need any spare parts,
please order genuine parts from your local dealer.