Language Setting; Mounting The Camera; Setup Mode - MINOX DTC 395 Manual De Instrucciones

message in the display. After inserting the proper card correct-
ly, you can continue with setting your camera.
Note: If the SD card was used to store data in other devices,
reformat the SD card on a PC. By reformatting the card, all pre-
vious data will be deleted to ensure error-free operation. If the
SD card has only been used in the DTC 395, formatting can be
done with camera as well. It is recommended to take some test
photos to make sure that the SD card is functioning properly.

Language setting

The default language settings of your DTC 395 wildlife
camera are in German. To change the language, please
follow these steps:
1. Move the main switch to "SETUP".
2. You will now be in the manual photo release mode.
3. Push the MENU button to enter the main menu
of the camera.
4. Push the "down" arrow button until you reach "Sprache".
5. Push OK.
6. Using the "up" and "down" buttons, choose your language.
7. Push OK.
8. The camera will now go back to the main menu.
Your camera is now set to the language of choice.

Mounting the camera

1. Mounting strap: The mounting bracket on the back of
the camera can be used to mount the camera on a tree
or post. The strap can be pulled through the bracket and
around the tree or post and then tightened. Once the camera
has been mounted, it can be turned 90° and removed from the
bracket, and reattached in the same way. This enables a quick
and easy removal of the camera to make necessary settings,
40
exchange the batteries or remove the SD card, without having
to reposition the camera afterwards.
2. Tripod: The ¼" socket at the bottom of the mounting
bracket can be used to mount the camera on a tripod or the
wall mounting bracket included in the scope of delivery.
3. Wall mount: The DTC 395 can be mounted on a wall or
ceiling with the wall mount (included in the scope of delivery).
Please make sure that the fastening screws are tight before
attaching the camera.

5. SETUP mode

Set your DTC 395 camera to "SETUP" mode (move main switch
to middle). The camera will automatically be set to "Manual
operation" mode (in this mode, you can record test photos
and videos). Press the menu button to access the main menu
of the camera.
Here you can select various basic settings for camera operati-
on. The factory default settings are shown in bold lettering
in the following. You can simply ignore each menu item where
you wish to retain the factory default setting.
a) Mode: Photo, video, photo+video, record photos and
videos at fixed intervals. First select whether you want the
camera to record photos or videos. In "Photo+video" mode,
the camera will record a preselected number of photos
and videos. If you select the option for recording photos
or videos at specific intervals, the movement sensor will be
automatically deactivated.
b) Photo quality: Here you can select from various photo
resolution options. We recommended retaining the default
setting 5M. You can select a higher resolution for better
41