AEG SCT81800S1 Manual De Instrucciones página 14

14 www.aeg.com
Problem
The appliance is
noisy
The appliance does
not operate. The
lamp does not oper-
ate.
The lamp does not
work.
The buzzer sounds.
The Alarm light
flashing.
The compressor op-
erates continually.
The compressor
does not start imme-
diately after press-
ing the FROSTMAT-
IC or COOLMATIC
button, or after
changing the tem-
perature.
Possible cause
The appliance is not sup-
ported properly
The appliance is switched
off.
The mains plug is not
connected to the mains
socket correctly.
The appliance has no
power. There is no volt-
age in the mains socket.
The lamp is in stand-by.
The lamp is defective.
The temperature in the
freezer is too high.
The temperature is not
set correctly.
The door is not closed
correctly.
The door has been
opened too frequently.
The product temperature
is too high.
The room temperature is
too high.
This is normal, no error
has occurred.
Solution
Check if the appliance
stands stable (all the four
feet should be on the
floor)
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electri-
cal appliance to the mains
socket.
Contact a qualified electri-
cian.
Close and open the door.
Refer to "Replacing the
lamp".
Refer to "High Tempera-
ture Alarm".
Set a higher temperature.
Refer to "Closing the
door".
Do not keep the door
open longer than necessa-
ry.
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Decrease the room tem-
perature.
The compressor starts af-
ter a period of time.