Tabla De Contenido; Symbols Used In This Document; Overview Drawing - Grundfos Unilift AP Serie Instrucciones De Instalación Y Funcionamiento

CONTENTS
1. Symbols used in this document
2. Overview drawing
3. Applications
4. Functions
5. Storage and operating conditions
6. Safety
7. Electrical connection
8. Installation
8.1 Pipe connection
8.2 Installation dimensions
8.3 Pump location
8.4 Free-standing installation
8.5 Adjustment of cable length for float switch
9. Operation
9.1 Starting
10. Maintenance and service
10.1 Oil
10.2 Pump construction
10.3 Cleaning the pump
10.4 Contaminated pumps
10.5 Replacement of parts
11. Technical data
11.1 Sound pressure level
12. Fault finding chart
13. Disposal
Warning
Prior to installation, read these
installation and operating instructions.
Installation and operation must comply
with local regulations and accepted
codes of good practice.

1. Symbols used in this document

Warning
If these safety instructions are not
observed, it may result in personal
injury!
If these safety instructions are not
observed, it may result in malfunction
Caution
or damage to the equipment!
Notes or instructions that make the job
Note
easier and ensure safe operation.

2. Overview drawing

Page
5
5
5
6
6
6
7
Discharge
7
port
7
7
7
8
8
8
8
9
9
Pump inlet
9
9
Fig. 1 Unilift AP-B pump
10
10
3. Applications
10
The Grundfos Unilift AP35B and AP50B pumps are
10
single-stage submersible pumps designed for the
11
pumping of wastewater.
11
The pumps are capable of pumping water containing
a limited quantity of solids without being blocked or
damaged.
Caution:
The pumps are not designed for pumping stones and
similar materials.
The pumps are designed for automatic operation
with float switch and for manual operation. The pump
can be installed in a permanent installation (on auto-
coupling or as a free-standing pump) or used as a
portable pump.
Incorrect use of the pump, for example resulting in
blockage or wear of the pump, is not covered by the
warranty.
Handle
with clamp
5