Description Of Work Station; Graphics; Separate Parts; Connection To The Mains - Silca BravoIII Manual De Instrucciones

Operating manual - English
5.4

Description of work station

The key-cutting machine needs only one operator, who has the following controls at his/her disposal:
Control panel:
placed on the left-hand side of the machine; controls the machine completely, through the following
controls:
• master switch (C)
• motor start switch (P)
• push button (M) to activate the brush
• carriage movement lever (L), placed at the bottom left-hand side
• carriage handle (V)
• carriage release push button (Q)
M
P
L
Fig. 9
5.5

Graphics

THE USE OF
PROTECTIVE GOGGLES
IS COMPULSORY
NOTICE OF DANGER:
CUTTER IN MOTION
TRACER POINT
WITH MICROMETRIC
REGULATION
0.002"
5.6

Separate parts

The separately packed parts must be installed on the BRAVO III with EZ-Jaw key-cutting machine by
the purchaser, as follows:
Connection wire
Connect the supply wire to the inlet on the back of the machine.
5.7

Connection to the mains

For the safety of the operator and the machine it is important to ensure that the machine is connected
to the proper mains voltage by means of an earthed differential switch.
Q
V
BRUSH PUSH BUTTON
DO NOT EXPOSE TO RAIN OR USE IN DAMP LOCATIONS
NE PAS EXPOSER A LA PLUIE OU DES LIEUX HUMIDES
WARNING LABEL (X) (fig.9)
Copyright Silca 2010
BRAVO III with EZ-Jaw
DO NOT EXPOSE TO RAIN OR USE IN DAMP LOCATIONS
X
MOTOR START-UP SWITCH
C
13