Safety; Technical Data - Silca BravoIII Manual De Instrucciones

Operating manual - English
3.1

Safety

• Cutter motor protection
ATTENTION: the cutter motor is protected from overheating by a device (inside the motor) that stops it when
it reaches a dangerous temperature.
This condition can occur when the machine motor is left on continuously, with high ambient
temperatures or in severe working conditions. If the cutter motor overheats it cuts out
automatically. In such cases proceed as follows:
a) turn off the master switch (C).
b) let the motor cool for at least 2 hours then use the machine normally.
• Start-up
The master switch (C) has a safety function that prevents untimely start-up when voltage returns after
a cut-out.

Technical Data

3.2
ELECTRICAL
PROPERTIES:
MOTOR:
CUTTING TOOL:
MOVEMENTS:
CLAMP:
MAXIMUM
LENGTH OF CUTS:
SAFETY DEVICES:
DIMENSIONS:
CUTTING NOISE:
NOISE POTENTIAL:
WEIGHT:
120V - 60Hz - 200W
1 speed single phase
Super Rapid Steel
on permanently lubricated bearings and sintered, self-cleaning, self-
lubricating bushings
high precision, four sides
42 mm
motor start-up by means of carriage pick-up with gauges in the idle position
width: 400 mm depth: 520 mm
Lp (A) = 79 dB (A) - brass keys
Lw (A) = 90,5 dB (A) - steel keys
21 Kg.
Copyright Silca 2010
BRAVO III with EZ-Jaw
height: 280 mm
9