Battery Run Time - Chauvet DJ EZwedge Tri Guía De Referencia Rápida

EZwedge™ Tri QRG
Overview
(cont.)
AC Power
Power Linking
Fuse
Replacement
Charging the
Battery
Battery Run
Time
IRC-6 (Infrared
Remote
Control)
On/Off Switch
DMX In
This product has an auto-ranging power supply that can work with an input
voltage range of 100 to 240 VAC, 50/60 Hz.
For the maximum number of EZwedge™ Tri products that you can power
link at each voltage, see the sticker on the product or the User Manual.
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and
replace with a fuse of the exact same type and rating.
5. Re-insert the fuse holder and reconnect power.
The EZwedge™ Tri comes with a rechargeable lithium battery for cable-free
operation. To charge the battery, simply plug in the external power cord at any
time before, during, or after operation. You can charge the battery with the LEDs
off by leaving the power switch in the Off position. The indicator light on the
external power supply turns red while the battery is charging, then it turns green
when the battery is done charging.
For optiomal battery life, charge the EZwedge™ Tri battery for 24 hours
prior to initial use.
Maximum Run Time
(all colors on)
Up to 8 hours
The EZwedge™ Tri is compatible with the included IRC-6 infrared remote
controller from CHAUVET® DJ. For more information on the IRC-6 or to
download instructions, go to
M12 Threaded
Mounting Hole
Maximum Run Time
(single color on)
Up to 20 hours
www.chauvetlighting.com
4
EN
DMX Out
Recharge Time
6 hours
.