Strobe; Program Time; Configuration (Dmx); Starting Address - Chauvet DJ GigBAR MOVE+ ILS Manual De Instrucciones

Strobe

To set the strobe on the GigBAR MOVE + ILS, follow the instructions below:
1. Press <MENU> to view the main menu on the display.
2. Use <UP> or <DOWN> until AUTO or SOUND is selected.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Strobe.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to set the strobe from 0–20.
7. Press <ENTER>.

Program Time

To set the program time on the GigBAR MOVE + ILS, do the following:
1. Press <MENU> to view the main menu on the display.
2. Use <UP> or <DOWN> until AUTO or SOUND is selected.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Program Time.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to set the timer from 0–255 (seconds).
7. Press <ENTER>.

Configuration (DMX)

The GigBAR MOVE + ILS works with a DMX controller. Information about DMX is in the CHAUVET DMX
Primer, which is available from the Chauvet website:
http://www.chauvetlighting.com/downloads/DMX_Primer_rev05_WO.pdf.

Starting Address

When selecting a starting DMX address, always consider the number of DMX channels the selected DMX
mode uses. If the starting address is set too high, access to some of the product's channels could be restricted.
The GigBAR MOVE + ILS uses 3 DMX channels, which defines the highest configurable address to 463.
For information about the DMX protocol, download the DMX Primer from www.chauvetdj.com.
To select the starting address, do the following:
1. Press <MENU> to view the main menu on the display.
2. Use <UP> or <DOWN> until DMX is highlighted.
3. Press <ENTER>.
4. Press <ENTER> again.
5. Use <UP> or <DOWN> to select the DMX Channel: 3CH, 28CH, or 50CH.
6. Press <ENTER>
7. Use <UP> or <DOWN> to select Address.
8. Press <ENTER>
9. Use <UP> or <DOWN> to increase or decrease the starting address.
10. Press <ENTER>.
Page 16 GigBAR MOVE + ILS User Manual Rev. 3
Operation