Temperature Alarm - Bresser TemeoTrend SW Manual De Uso

as described above by pressing and holding the ▼ button for
3 seconds and while the wave icon is blinking, press and hold
the ▼ button again for 3 seconds. The temperature indicator
will start to blink indicating that a new sensor is being searched
for and will be logged in.
VIEWING REMOTE (CHANNEL) TEMPERATURE
Select the TEMPERATURE window.
Static Display: Press the CHANNEL button to select measure-
ments from different remote sensors (channel 1, 2 or 3).
Channel Auto-Scan Display: To enable an automatic scan of all
present channels, press and hold CHANNEL, until the
displayed. The measurements from each remote channel will be
alternately displayed with a 5 seconds viewing.
NOTE: the channel auto-scan feature can be activated only if there
are more than one remote sensors operating and are set to diffe-
rent channels.
PROGRAMMING TEMPERATURE IN CELSIUS OR FAHREN-
HEIT
Select the TEMPERATURE window.
Press and hold MODE button for 3 seconds to toggle the tempe-
rature unit in Celsius (ºC) or Fahrenheit (ºF).

TEMPERATURE ALARM

Select the TEMPERATURE window.
Press ALARM button selecting the desired alarm, the upper tem-
perature alert with
lower temperature alert with
OFF). Press and hold ALARM button until the temperature di-
gits fl ashing. Adjust the temperature digits using the UP (▲) or
DOWN (▼). Press and hold either button for fast setting. Press
the ALARM to confi rm selection and return to the temperature
▬
icon (if disabled, display shows OFF), or
▲
icon (if disabled, display shows
41
GB/IE
icon is