OPERATION OF THE TEMPERATURE WINDOW
For all operations described in Chapter 4.2, press UP ▲ or
DOWN ▼ until the
value, begins to fl ash.
FORCED SEARCH FOR REMOTE SENSORS
Select the TEMPERATURE window.
The main unit can be manually activated to search for the signal
from the selected remote sensor by pressing and holding the
DOWN ▼ button for 3 seconds
The wave icon above the current channel icon shows the con-
nection status of the corresponding remote sensor:
Icon
With this search procedure the device searches the same sensor
that was already previously logged in. If you replace the batteries
in the sensor, the sensor gives itself a new code and will then no
longer be recognized by the display unit. You can resolve this
problem by:
• removing the batteries from the display unit and replacing them
with new ones or
• if the batteries are still O.K., repeating the logging in procedure
icon, to the left of the indoor temperature
Searching for the signals from the remote sensor
Corresponding remote sensor signal received
No signals received for over 1 hour
40
Status
successfully