Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Q UI C KIE PU LS E
I. SINGLE POST HEIGHT-ADJUSTABLE ARMRESTS
1. Installation
a. Slide the outer armpost into the receiver mounted to the wheel chair frame.
b. The armrest will automatically lock into place.
2. Height Adjustment
a. Rotate release lever to stop.
b. Slide armrest pad up or down to desired height.
c. Return lever to locked position.
d. Push arm pad until upper armpost locks firmly into place.
3. Removing Armrest
a. Rotate release lever and remove the armrest.
4. Replacing Armrest
a. Slide armrest back into receiver.
b. Return release lever to locked position against armpost.
5. Adjusting Armrest Receiver Fit (tighten or loosen fit)
To tighten or loosen the fit of the outer armpost in the receiver:
a. Loosen the four bolts on the sides of the receiver.
b. With the armrest in the receiver, squeeze the receiver to achieve the desired fit.
c. Tighten the four bolts.
6. Adjusting Inner Armpost Fit
a. Two set screws are installed in the outer armpost.
b. Turn the set screws in or out until the desired fit is achieved.
J. SEAT DEPTH ADJUSTMENT
The seat depth can be adjusted in one inch increments on standard rehab seating.
1. Seat Frame Depth Adjustment
a. To adjust, remove the two bolts (A & B) from each side of the backrest pivot plate.
b. Reposition the backrest to the desired position.
c. Replace and retighten bolts on each side of the backrest pivot plate.
2. Back Angle Adjustment on Seat Frame
a. Remove the front securing bolt (A) on the side of the backrest hinge plate.
b. Loosen the lower rear bolt (B)
c. Set at desired angle. There are five holes (in 4º increments) to choose from.
d. Reinstall the front bolt and tighten both bolts securely.
K. CAPTAINS SEAT
22
The Captains seat back can be manually reclined, folded, or angle adjusted.
1. Adjusting the recline angle
a. To adjust, pull up on the release lever(C) located on the right side of the backrest.
b. Reposition the backrest forward or backward to the desired position.
c. Release the lever (C) and wiggle the backrest to make sure it locks in place.
2. Folding the Back (unoccupied)
a. To fold, Pull up on the release lever(C) located on the right side of the backrest.
b. The backrest should spring forward into the folded position as shown.
c. Release the lever.
d. To unfold the back, pull up on the release lever (C) and adjust the back to an upright
position.
14" - 16", 20" - 22" only
23
VIII. SET-UP, ADJUSTMENT, AND USE
(optional)
20
21
19
5
3
7
2
9
Height-Adjustable Armrest Key
1. Inner Arm Post
2. Receiver
3. Release Lever, Locked Position
4. Armrest Pad
5. Transfer Bar
6. Side Panel
7. Tension Adjustment Set Screw
8. Outer Arm Post
9. Receiver Adjustment Bolts
20
4
1
6
8
21
22
23
119832 Rev. D
Capítulos
Tabla de contenido
