Before you start
Magnetic Knob
With the cooktop powered on, if you put the magnetic knob over an unused
element on the control panel, the cooktop recognizes the knob and sets the power
level to 0. Then, you can change the power level using the knob.
NOTE
You can also set the power level by touching the element control with your finger.
See page 19.
18 English
NZ30K7880U_DG68-00823A-06_EN+MES+CFR.indb 18
The magnetic knob is a detachable control
knob with a magnetic base you can use to
set and adjust the power level of any of the
induction elements on your cooktop easily
and intuitively. To use the magnetic knob:
Place it in the center of the element
1.
control of your choice. The knob's
magnet holds it in place.
2.
Press the POWER key to turn on the
cooktop, and then press the element's
ON/OFF key within 20 seconds.
3.
Grasp and turn the magnetic knob to
set the element's power level.
Residual heat indicator
When an individual cooking zone or the cooktop is turned off, the presence of
residual heat is shown with an
,
appropriate cooking zones. Even after the cooking zone has been switched off, the
residual heat indicator goes out only after the cooking zone has cooled.
You can use the residual heat for thawing or keeping food warm.
NOTE
The uppercase '
' indicates higher temperatures than the lowercase '
WARNING
As long as the residual heat indicator is illuminated, there is a risk of burns.
WARNING
If the power supply is interrupted, the
about residual heat will no longer be available.
However, it may still be possible to burn yourself. This can be avoided by always
taking care when near the cooktop.
Cooking areas
•
The cooking areas on your cooktop are identified by permanent circles on the
glass cooking surface. For the most efficient cooking, fit the pan size to the
element size.
•
Pans should not extend more than ½˝ to 1˝ beyond the cooking area.
For more information on selecting proper types of cookware, refer to the
•
section "Use quality cookware in good condition". See page 25.
(for "hot") in the digital display of the
'.
,
symbol will go out and information
2018-08-29
2:27:53