Tabla de contenido
- FCC INFORMATION (U.S.A.).
ATTENTION: DO NOT MODIFY THIS UNIT!
This host device contains an FCC certified Bluetooth module:
RSL10 SIP transciver with FCC ID: 2APD9-RSL10SIP
This product meets FCC requirements once it is produced and assembled. Modifications not
expressly approved by GLOBAL TRAKTUS SL may void your authority, granted by the FCC, to
use the product.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
IMPORTANT: When connecting this product to accessories and/or another product use only high-
quality shielded cables. Cable/s supplied with this product MUST be used. Follow all installation
instructions. Failure to follow instructions could void your FCC authorization to use this product in
the USA.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
This device includes a Li-Po Battery in conformity with IEC/EN 62133:2012 standard.
- INDUSTRY CANADA REGULATORY INFORMATION.
This product meets the applicable Innovation, Science and Economic Development Canada
technical specifications.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following
two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
This host device contains a RSL10 SIP Transceiver Certified Bluetooth Module with IC: 23763-RSL10SIP
The wireless product complies with IC radiation exposure limits for portable devices.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment.
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and
compliance with RSS102 RF exposure, users can obtain Canadian information on RF exposure and
compliance.
This device includes a Li-Po Battery in conformity with IEC/EN 62133:2012.
13
Tabla de contenido
