Tabla de contenido
Idiomas disponibles
Idiomas disponibles
THE FOLLOWING WIRING SHOULD BE APPLIED WITH DISABLED AMPLIFIERS.
First, connect the supplied plug-in power supply with the TWO IN ONE SYS-
TEM. The corresponding socket is identified on the back as
For strain relief, the cable can be looped through the U-shaped cut-out
next to the socket.
Once the unit is powered, and depending on the switch position, a green
LED (
AMP 1) or a red LED (
3
cket labelled
4
the amplifier #1 To do this, use a shielded instrument cable. Next, the
speaker output of this amplifier labelled
the TINO) should be connected. To do this, use a speaker cable. In the
same way, connect the amplifier #2. Now connect the speaker to the socket
labelled
„SPEAKER CABINET" (backpanel of the TINO).
6
Lastly, the connection to the switch must be made. On the back of the
TINO SYSTEM, the socket
purpose. As already mentioned, a switcher or a (on/off) footswitch can be
connected here. Devices using relay outputs are best suited as switchers.
The
REMOTE CONTROL socket is fitted with a switch contact. As soon as
7
the socket is in use, the manual switch (
panel ceases to function.
Before turning on the amplifier, please double check the wiring. A short
play with reduced volume is recommended. In the event of an incorrectly
connected cable, the danger of damaging an amplifier is less when playing
at low volume.
SpEAkER OUT
AMp 1
INpUT
GITARRE /
INSTRUMENT
8
AMP 2) lights up. Now connect the so-
3
„TO AMP 1" on the front panel with the input socket of
„REMOTE CONTROL" has been provided for that
7
CABINET
2
4
1
„SPK OUT AMP 1 (backpanel of
5
AMP1 /
3
3
FOOTSwITCh
ODER REMOTE
6
5
1
3
„9V DC IN".
2
AMP2) on the front
SpEAkER OUT
INpUT
7
AMp 2
Tabla de contenido
