Putting Into Operation - Costan VALZER NEXT Serie Instrucciones De Uso

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 54
PUTTING INTO
OPERATION
If the cabinet has been
sharply tilted while being
sited or for mounting of
accessories, it must be
left to stand for at least three hours before
being started to allow the lubricating oil to
settle in the compressor.
Failure to do so can cause total destruction of
the compressor refrigerating system.
Check that the voltage on the identification
plate is the same as that of the network.
THE ELECTRICAL SUPPLY LINE
TO WHICH THE REFRIGERATOR
WILL HAVE TO BE CONNECTED IS TO BE PROTECTED BY A VERY SENSITIVE
DIFFERENTIAL SWITCH (Rc=16A,Dc=30mA); IT IS ALSO TO BE LINKED TO THE
GENERAL EARTHING PLANT.
Follow the manufacturer's instructions to install the unit, using qualified personnel and complying with
the electrical regulations for the specific country.
Incorrect installation may cause injury and damage; the manufacturer is not liable for this.
The manufacturer disclaims all responsability for any damage to people or things due to incorrect
observance of this rule. Earthing is necessary and compulsory by law. Absolutely never use reduc-
tion units, patch cords, adapters or multiple socket outlets to connect the counter. DIRECTLY
connect the equipment to the mains.
unilikely to be struck, caught or stepped on, away from water and the other liquids and heat sources
and must not be damaged.
In case of breakage of the power cable of the cabinet, it must be replaced by the manufacturer or by
instruction it change of it. The plug must still be accessible even after installing the unit.
SEASONAL USE
When the unit is not used for a long time, please take note of the following procedures:
- unplug the unit.
- clean and dry the tank well.
- leave the glass door open to avoid possible formation of bad odours.
- cover the unit with a curtain, place it in a dry room and sheltered from the atmospheric agents.
PERIODIC MAINTENANCE
WARNING!
ANY WORK CARRIED OUT ON THE APPLIANCE BY THE USER STRICTLY
REQUIRES THE POWER PLUG BEING DISCONNECTED FROM THE
MAINS SOCKET.
Inspect the power cable to see if it is damaged.
If the power cable is damaged, do not use the appliance and try to repair it: it must be replaced by
the manufacturer or its customer service department or by a similarly qualified person, in order
to prevent any risks. No protection (grill or guard) should be removed by unqualified personnel
and strictly avoid operating the appliance with these protections removed.
The replacement of lamps must be carried out only by an Authorized Service Center.
The lamps have to be replaced by identical lamps only.
The cable should be fully extended and located where it is
-21-
Tabla de contenido
loading

Tabla de contenido