Miniland digimonitor 3.5" Manual De Instrucciones página 18

Please note:
· When the battery charger indicator (16) on the Intercom unit starts to blink continuously &
INTERCOM BATTERY LOW appears on screen, it's time to recharge the batteries.
· Remove the batteries during long period of non-use.
ATTENTION: When INTERCOM BATTERY LOW once appears on screen, you cannot
operate any functions at all. Please recharge the Intercom as soon as possible.
Use AC/DC adaptor:
· Check that only approved Li-ion rechargeable battery is installed in the Intercom.
· Plug the connector of the AC adaptor to the socket on the unit.
· Plug the adaptor into a mains socket.
· Switch on the power switch of the unit.
Camera:
· Unscrew and remove the battery cover at the bottom of the unit.
· Insert 4 x AA size alkaline batteries (not supplied) in accordance with marking of the battery
compartment. Refit the battery cover and secure with the screws.
Please note:
· When the power indicator on the Intercom unit starts to blink continuously. It's time to
change the batteries. It is advisable to use AC/DC adaptor (supplied) for long period of use.
· Remove the batteries during long periods of non-use.
Warning:
Improper use of the adaptor may cause malfunction of the units. Please consult the Miniland
technical service for any queries. Use only the AC adaptors supplied in the packaging.
Your Intercom monitor has a built-in recharging circuit. Before plugging in either AC adaptors,
please make sure only approved rechargeable Li-ion batteries (or no batteries) are inside the
battery compartment.
OPERATING INSTRUCTIONS
· To turn ON the camera unit, press the ON/OFF switch (1) located at the front of the camera
for about 2 seconds.
Camera MODE Switch (12)
· CAMERA – in this mode the camera transmits an image and sound continuously, a useful
function for uninterrupted surveillance.
· AUTO – in this mode the camera is on standby and is only activated when a noise is
detected – subject to the sensibility of the programmed volume.
· This mode is particularly useful at night as even though it is connected to the intercom no
sound is transmitted, helping you to sleep more easily. Whenever a noise is detected the
camera will resume the transmission of image and sound.