Steam For Heating Drinks; Maintenance And Daily Cleaning - Siemens TK 53 Serie Instrucciones De Uso

Steam for heating drinks

¡
Risk of burns
The nozzle gets very hot. Do not touch the
metal parts.
The appliance must be ready for use.
● Push the sleeve on the nozzle 8 all the
way up.
● Press the steam button
start to flash.
i
The appliance will now heat up for
approx. 20 seconds.
● Immerse the nozzle 8 deep into the liquid
you want to heat.
● As soon as the LED
rotary button 6 to
¡
Risk of scalding
When the dial 6 is set to
8 may sputter a little. Escaping steam is
very hot and may cause liquid to sputter. Do
not touch the nozzle 8 or point it at anyone.
● End the process by turning the dial 6
back to "O".
i
To generate more steam, press the steam
h
button again and repeat the whole
process.
Note: When the nozzle 8 has cooled down,
clean immediately. Dried residue is difficult
to remove.
h
. The LED will
J
lights up, turn the
g h
/ .
g h
/ , the nozzle
Maintenance and
daily cleaning
¡
Risk of electric shock!
Unplug the appliance before cleaning it.
Never immerse the appliance in water.
Do not use a steam cleaner.
● Wipe the outside of the appliance with a
damp cloth. Do not use scouring agents.
● Always remove any limescale, coffee,
milk or descaling fluid residue immedi-
ately. Such residue can cause corrosion.
● New sponge cloths may contain salts.
Salts can cause rust film on stainless
steel and must therefore be washed out
thoroughly before use.
● Wash all removable parts by hand only.
● Rinse out the water tank 11 with water
only.
● Remove, empty and clean the trays for
coffee grounds 17 and residual water 18.
● Wipe out the inside of the appliance (tray
holders).
● Open the door to the brewing unit 21 and
remove any coffee residues. Close the
door.
Note: If the appliance is cold when
switched on, or if it is switched off after
dispensing coffee, it rinses automatically; in
other words the system cleans itself.
Nozzle 8 for hot water / steam
● Unscrew the nozzle 8 from the steam
pipe.
● Dismantle all parts (Fig. D).
● Clean with a caustic cleaning solution and
a soft brush. Clean the tip of the nozzle
8c with a blunt needle.
● Thoroughly rinse and dry all parts.
en
21