Checking Bolts And Nuts; Motor Exterior; Cleaning Cooling-Water Passages - Yamaha F80A Manual Del Propietário

q
e
EMU00408*

CHECKING BOLTS AND NUTS

1) Check that bolts securing the engine
and the nut securing the flywheel are
tightened with their specified tighten-
ing torque.
2) Check the tightening torque of other
bolts and nuts.
EMU00409

MOTOR EXTERIOR

EMU00410
Cleaning the Outboard Motor
After use, wash the exterior of the out-
board with fresh water.
Flush the cooling system with fresh
water.
NOTE:
Refer to Flushing Cooling System instruc-
tions in "TRANSPORTING AND STORING
F1029
OUTBOARD MOTOR".
EMU01111
CLEANING COOLING-WATER
PASSAGES
Flushing device equipped model
Perform this procedure right after opera-
tion for the most thorough flushing.
1) After shutting off the engine, unscrew
w
the garden-hose connector 2 from
the fitting 1 on the bottom cowling.
2) Screw the garden-hose connector 2
onto a garden hose 3 which is con-
nected to a fresh-water supply.
3) With the engine off, turn on the water
tap and let the water flush through
the cooling passages for about 15
minutes. Turn off the water and dis-
connect the garden hose 3.
4) When flushing is complete, reinstall
the garden-hose connector 2 on the
000845
fitting 1 on the bottom cowling.
Tighten the connector securely.
4-30
GB