WEG SSW-05 Manual Del Usuario página 21

19.3.3. Signaling/Indications on the HMI-SSW05-RS Display:
Soft-Starter Status:
Soft-Starter is ready to be started.
Soft-Starter is in fault condition. The code is flashing. In our example, the fault
message is E03 (Phase Loss).
Soft-Starter is executing the function "Load factory setting (P204)"
Note
The display also flashes, besides the fault condition, in the following condition:
Attempt to change parameter with incorrect password (P000 – Access Parameter);
Attempt to change not permitted parameter. Example: Parameters that cannot be
changed with running motor.
19.3.4. Parameter Viewing and Programming:
All SSW-05 settings can be made through parameters. The parameter are shown on the display
by the letter P followed by a number:
Example (P264):
264 = parameter number
Each parameter is associated with a numerical value (parameter value), that corresponds to the
selected option among the available ones for this parameter.
The parameter values define the Soft-Starter programming or the value of a variable (e.g.: current,
voltage). For Soft-Starter programming you should change the parameter content(s).
ACTION
Turn ON the Soft-Starter
Press the key
Use the keys and
to reach P264
Press the Key
Use the keys and
Press the Key
Installation and Operation Manual - SSW-05 Plus
HMI DISPLAY
English-21
DESCRIPTION
Soft-Starter is ready to be operated
Select the desired parameter
Numerical value associated with the
parameter
(2)
Set the new desired value
(1) (2)
(2)