Safety Instructions - Bosch DHD Instrucciones De Instalación

z_ SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE.
READ AND SAVE THESE INSTRUCTIONS
Z_ WARNING
To reduced the risk of fire, electric shock,
or injury to persons, observe the follo-
wing:
A. Installation work and electrical wiring
must be done by authorized person(s)
in accordance with all applicable
codes and standards, including fire-
related construction.
B. Sufficient air is needed for proper
combustion and exhausting of gases
through the flue (chimney) of fuel bur-
ning equipment to prevent backdraf-
ting. Follow the heating equipment
manufacturer's guideline and safety
standards such as those published by
the National Fired Protection Associa-
tion (NFPA), and the American Society
for Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE),
and the local code authorities.
C. When cutting or drilling into wall or
ceiling, do not damage electrical
wiring and other hidden utilities.
D. Ducted fans must always be vented
to the outdoors.
E. Always unplug or disconnect the
appliance from the power supply
before servicing.
R This unit is designed for indoor use
only. Use this unit only in the manner
intended by the manufacturer.
G. Make certain the cooktop is appro-
priate for use with a downdraft vent.
H. Not intended for use with professio-
naFstyle cooktops.
Z_ WARNING
For general ventilating use only. Do not
use to exhaust hazardous or explosive
materials
and vapors.
To reduce risk of fire and to properly ex-
haust air, be sure to duct air outside. Do
not vent exhaust air into spaces within
walls, ceilings, attics, crawl spaces or
garages.
To reduced the risk of fire, use only metal
duct work.
To reduce the risk of fire, electric shock
and injury to persons, Downdraft must
be used with Internal, Remote or Inline
Blower.
To reduce the risk of fire or electric
shock, do not use the fan with any solid-
state speed control device.
This appliance has been found to be in
compliance with UL 507 Standard for
Electric Fans and CAN/CSA-22.2 No.
113 Canadian Standard for Fans and
Ventilators. It is the responsibility of the
owner and the installer to determine if
additional requirements or standard
apply in specific installation.
_rts Needed (standard)
Measure
bhillips Head Screwdriver
Duct Tape
(configuration varies
depending on location; See pages 7-12
for further information)
Qdditional Sheetmetal screws (as neces-
ary for ductwork installation)
aw (or equivalent for cutting counter-
x 1 1/4" Wood Screws (4)
4mb Bob
reach Remote or Inline Blower
s Needed (special)
pecial Blower
ansition Box (for use only with Inline
and Remote Blowers)
ecirculation Module (used only for
recirculation applications)
Note: Downdrafts work with these
blowers: 600 CFM Integrated, Remote or
Inline Blowers 1000 CFM Remote or Inline
Blowers
_8 s Supplied
owndraft assembly (1)
Sheetmetal Screws (8)
ower Cord Strain Relief (1)
ardware for brackets on vent (2)
emote Blower Pigtail