Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Remote orInline B lower (see F igures 10
and 11forfurther detail):
[] A.Remove
junction box cover and con-
nect conduit with 5wires f rom remote
blower. Hook u pwires p er W iring.Fig.
10.
Replace
junction box cover.
[] B.Attach D uct Transition
Box atmoun-
tinghales with sheetmetal
screws.
[] C.Feed r emote blower pigtail through
strain r elief.
[] D.Attach strain r elbf t odowndraft
near
junction box.
[] E. C onnect pigtail todowndrafl
at6pin
connector.
[] RRun pigtail wires t ojunction box.
[] G.Inside junction box, connect conduit
with five wires f rom remote orinline b lo-
wer. Use aconduit connector
tosecure.
Note: Blower and duct transition box may
beinstalled with duct o utlet left, d own o r
nght. Install blower orduct transition in
such away that a ccess panels can be
removed
forservice.
[] H.Place the cooktop incountertop
ope-
ning w ith the rear edge o fcooktop over-
lapping the front e dge o fthe vent. Make
sure rear edge o fcooktop does n ot b ind
against front ofsnorkel.
Follow t hemanufacturer's
installation
In-
structions
forinstalling
gasket strips,
protective
heat tape (ifrequired),
secu-
ring the cooktop tothe countertop
and
making thecooktop electrical
and/or gas
connections.
Note: Check b oxes astasks a re completed.
/
/
\\
6 Pin Connector
/
Duct Transition
Box
Ci
Strain Relief
Remote Blower
Pigtail
/
Conduit
To Re-
mote Blower
Fig. 10 - Remote
Blower
10
Tabla de contenido
