Installing The Seat Board; Fully Inflate The Air Chambers; Outboard Motor Installation; Deflating And Packing - V-QUIPMENT Traveller VB200T Manual Del Propietário

Model TRAVELLER, a boat with an inflated floor:
VB200T - VB230T - VB270T - VB300T - VB330T
• Put in the air floor and inflate it to around 70%.
• Install the seat board. Slide it onto the mounting rail, see 4.4.
• Inflate the tubes to 100%, to max. 0,25 bar, see 4.5.
• Inflate the air floor to 100%, to max. 0,7 bar .
• Inflate keel to 100%, to max. 0,25 bar.
Model FRONTIER, a boat with an aluminium hull with V-keel:
VR240B - VR270B - VR270 - VR300 - VR330
• Install the seat board. Slide it onto the mounting rail, see 4.4.
• Inflate the tubes to 100%, to max. 0.25 bar, see 4.5.
4.4

Installing the seat board

4.5

Fully inflate the air chambers

A pressure relief valve is placed in air chamber -1- (bow).
The pressure of the air chambers -2- and -3- (starboard and port)
must not become too high during full inflation. to prevent distortion
of the partition.
All models
• Install the oars.
• Install the drain plug.
Inflatable boats 200 - 330
n
ote
5

Outboard motor installation

Selecting the optimum outboard motor is critical to the performance
and long life of your boat.
Never install an outboard motor with a higher power than indi-
cated as maximum power on the builders plate.
• Unlock motor for tilting and mount the motor properly.
• The motor should be in the centre of the transom.
• It is important that the outboard motor is installed at the correct
height. Secure the clamps and make sure that they are thoroughly
tightened.
• Adjust the motor trim angle. With an incorrect trim angle of the
motor the nose of the boat will go up or down during cruising.
• For detailed information, consult the manual of your motor or
contact the supplier of your motor.
6

Deflating and packing

Before deflation, make sure the boat is clean and dry.
• Open valves and let the air out of each chamber. to deflate the
boat.
• To avoid sudden pressure changes on the internal bulkheads try
to let the air out as evenly as possible.
• Remove seat and oars.
Model EXPLORER, a boat with an aluminium floor:
• Remove the aluminium stringers.
• First remove no. 2 and no. 3 floor boards. Then, remove no. 1 and
no. 4 floor boards.
• Place both side air chambers toward inside of the boat and roll
slowly from both ends until all air is expelled.
• Store the boat inside the carrying bag.
Model TRAVELLER, a boat with an inflated floor:
• Deflate the air floor.
• Tilt both side air chambers to the inside of the boat and, from both
ends, slowly roll them up until all the air has been expelled.
• Store the boat inside the carrying bag.
Model FRONTIER, a boat with an aluminium hull with V-keel:
• Tilt both side air chambers and the bow towards the hull and
slowly expel all air from the chambers.
ENGLISH
W
arninG
VQ12095
17