Accessories And Attachments; Adjusting The Helmet; To Check Helmet Size; To Adjust The Fit - Trek Bicycle Bontrager Serie Manual De Instrucciones

Accessories and attachments

Adjustable (and removable)
visor (screws)
Cover holes when visor
Removable visor
not in use
(mushroom plugs)
1
Front Blendr mount
(GoPro & Bontrager Ion
light compatible)
(not available on all helmets)
Neo Visor
2
2
Rear Blendr mount
(Flare light compatible)
6

ADJUSTING THE HELMET

NOTES: All directions (left, right, front, rear) refer to the helmet as worn on the head.
For an illustration that shows how to operate a feature or fit system, see pages 4-6.

To check helmet size

Some models of Bontrager helmets offer different sizes to fit different head sizes. To
check for the right size, put it on your head and adjust the rear fit system (see page 4).
A good fit is snug, but not tight.

To adjust the fit

1. Place the helmet on your head. It should be level so that it sits just
above your eyebrows and covers your forehead.
Unlock the strap dividers.
2. On the left side, hold the buckle under your chin, and slide the strap
divider just beneath your earlobe. The straps should sit flat against your
head.
Lock the strap divider.
3. From the right side of the helmet, pull any left-side slack across the
back of the helmet.
1
Then repeat Step 2 on the right side.
4. Make sure the chinstrap is correctly threaded through the right
buckle, and fasten the buckle.
To keep the chinstrap from loosening or flapping, it must be tucked
through the keeper.
5. Make sure the buckle is correctly fastened:
• Listen for a click as the buckle engages.
• Attempt to pull the buckle apart with the chinstraps. It should not
come apart.
6. Adjust the chinstrap so that it is positioned snugly against the
bottom of your jaw as shown.
7