Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Checking the remaining battery capacity
(B9017A)
Indicating lamp
F Capacity
(C)
E
orange
Indicating lamp
E
F
orange
001254
When charging
When the charging begins, the first (far left) indicating
lamp begins to flicker. Then, as charging proceeds, the
other lamps light, one after the other, to indicate the
battery capacity.
When using
When the tool is switched on, the lamps will light to
indicate the remaining battery capacity. When the tool is
switched off, the light goes out after approx. 5 seconds. If
the battery has not been used for a long time, or is
needed refresh charging, the orange lamp begins to
flicker. Use Makita refreshing adapter to refresh the
battery.
CAUTION:
A battery cartridge extracted from the charger that
•
has been unplugged with the battery cartridge
inserted does not work even if it is inserted in the
tool. At this time, recharge it for about five seconds
before use.
Switch action
1
001255
80% - 100%
60% - 80%
40% - 60%
10% - 40%
0% - 10%
Capacity
80% - 100%
60% - 80%
40% - 60%
10% - 40%
0% - 10%
1. Switch trigger
CAUTION:
Before inserting the battery cartridge into the tool,
•
always check to see that the switch trigger actuates
properly and returns to the "OFF" position when
released.
To start the tool, simply pull the switch trigger. Tool speed
is increased by increasing pressure on the switch trigger.
Release the switch trigger to stop.
Reversing switch action
1
A
001257
This tool has a reversing switch to change the direction of
rotation. Depress the reversing switch lever from the A
side for clockwise rotation or from the B side for
counterclockwise rotation.
When the reversing switch lever is in the neutral position,
the switch trigger cannot be pulled.
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
When not operating the tool, always set the
•
reversing switch lever to the neutral position.
The remaining Battery capacity
Auto-stop mechanism
(C)
E
E
001258
The tool stops automatically (Red color lamp lights on)
after the battery capacity reaches under 20% to prevent
the lack of fastening torque. Charge the battery or use a
new fully charged one.
Auto-Stop setting for number of impacts
This tool has a convenient auto-stop mechanism that
allows you to preset the desired number of impacts in
5
1. Reversing
switch lever
B
F
F
Tabla de contenido
