Lid Lock; Preselection; Preselection Of Speed / Rcf-Value - OHAUS Frontier FC5515 Manual De Instrucciones

Ocultar thumbs Ver también para Frontier FC5515:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

EN-8
During the run you can call up the rotor type at any time by pressing the key "Door Open" (7).
3.2.2

Lid lock

The lid should only be put down slightly. An electromagnetic lid lock closes the lid, at the same time the word
"open" (M2) disappears (refer to figure 15).
As a sign that the centrifuge is ready for starting, in the display "RPM | RCF" (A-1) the word "close" (M1) appears.
Simultaneously the word "rotor" (M3) is displayed, as well as the code number of the rotor, which is in the
centrifuge system, "no 71" (M4). With that, all rotor specific data, like e. g. max. speed, acceleration etc., are
adopted.
ATTENTION:
Don't grip your fingers between lid and device or locking mechanism when closing the lid!
3.3

Preselection

3.3.1

Preselection of speed / RCF-value

This pre-selection is activated through the key "RPM | RCF" (4) (refer to figure 16 below). By pressing the key
once the word "rpm" (M5) flashes. By pressing the key twice the pre-selection of the centrifugal forces can be
selected. Then the flashing word "rcf" (M6) appears. You can set the
desired values with the adjusting knob (1). In the display (A-1) the regulated value is shown permanently, before,
during and after the run.
M2
M4
A-1
M5
A-1
4
5
Frontier
M3
M1
7
Figure. 15
M6
Figure. 16
TM
Centrifuge FC5515/FC5515R
1
1
Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Frontier fc5515r

Tabla de contenido