Ambient Conditions In The Place Of Operation; Electrical Connections - SICE A 92 Manual De Instrucciones

UNL Unloading
AB Antiroll bar
Relative humidity: 20% ÷ 90% (without condensation)
Temperature range: 5°C ÷ 35°C
The machine must not be operated in potentially explosive atmosphere.
The manufacturer has preset the aligner to operate with a power supply of 230 VAC.
It can be preset to operate on 115 VAC by setting the PC voltage change switch as
appropriate.
NOTES
- However, it is important to check that the monitor and printer are preset to operate with
voltages other than 230 VAC.
- The power supply cable supplied with the machine complies with the relevant regulations.
Any operation required for connecting the electrical board of the workshop must be
carried out exclusively by qualified personnel and complying with the regulations in
force, at the customer's expense and responsibility.
• The electrical supply line must be suitably sized in relation to:
1. the machine absorbed power, as specified on the machine data plate.
2. the distance between the machine and the electric hook-up point, in order that the voltage
drop at full charge does not exceed 4% (10% during the starting phase) in relation to the
rate value of the voltage on the machine data plate.
The user must:
•
1. provide the power suply cable with a plug in appliance with local electrical regulations
2. connect the machine to a dedicated power line with its own 30 mA circuit breaker
3. install fuses on the power supply line, suitably dimensioned according to the indications in
the general electric diagram in this manual
4. make sure that the workshop is provided with an efficient ground circuit.
• In order to prevent the machine being used by unauthorised personnel, it is advised to
disconnect the power supply plug when the machine remains idle (switched off) for long
periods of time
• If the machine is hooked up directly to the main electrical board, without a separate plug to
socket connection, a key switch or a switch that can be locked out must be installed to prevent
the machine from being used by non-authorised persons.
For correct and safe operation of the machine it must be connected to an efficient

Ambient conditions in the place of operation

ELECTRICAL CONNECTIONS

WARNING
WARNING
WARNING
54