EGAmaster 610NM Manual De Instrucciones página 11

Greases (free of resins and
acids)
Designation in accordance
with DIN 51502
Consistency class (DIN 51818)
Saponification type
Dripping point
Worked penetration
Temperature range
Multi-purpose greases for
antifriction and friction
bearings and gears
KL 2 K
2
lithium
185ºC
265 to 295
-25ºC to 125 ºC
OILER TYPES USED ON OR WITH OUR TOOLS
Oiler to mount on the machine or connect in the hose line
Setting the oiler: The adjustment screw is visible after
removing the screw plug. The oil supply is decreased by
tightening the screw, and by loosening the screw, more
oil gets into the machine. In most cases it is sufficient to
tighten or loosen the screw by ¼ or ½ of a turn. When
plugged, clean borehole (diam. 2mm) with wire.
Correct setting: When under pressure and with the filler
screw open, the oil must bubble slightly. The filling lasts
For stationary pneumatic machines and motors, the
lubrication is carried out by lined-up oilers for
Setting of oilers: Shut off air supply. Open plug. Loosen
visible lock nut with a socket wrench. Using a
screwdriver turn back the tightened screw plug by ¼ to
½ of a turn and then lock again. No oils are to get into
the borehole "a" when filling. Close plug and open the
Correct setting: A piece of paper held for a short time in
front of the outlet must be coated with oil without drops
Special greases for high-speed
-25ºC to 100ºC
for approx. 8 operating hours.
Line oiler
horizontal or vertical installation.
air supply.
forming.
miter gears
G 00h
00
sodium
145ºC
400 to 410
11