Axor 10456 1 Serie Instrucciones De Montaje página 4

1
2
3
3
1
4
8 mm
4
English
Installation
Turn the water off at the main before
beginning!
Cut the plaster shield so that it extends ⅜" above the
surface of the finished floor.
Remove the flush housing screws using an 8 mm Allen
wrench (not included).
Do not discard the screws!
Remove the flush housing.
(1) Position the tub filler on the rough .
(2) Pivot the tub filler so that it faces the correct direc-
tion .
(3) Make sure that the tub filler is level .
(4) Install the 6 screws (the 3 reserved screws from
the flush housing plus the 3 included with the tub
filler).
Tighten the screws using an 8 mm Allen wrench .
2