Tabla de contenido
FIGURE 32
FIGURE 33
X
MAI N TEN A N CE - Co nti nu e d
Removing a jammed strip
1. Turn the power switch to Off and remove any books
from the Cooling Rack.
2. Open the machine by pushing the eraser end of
a pencil (or similar object) through the hole in the
lower right corner of the machine (figure 32) until the
machine cover pops open slightly.
3. Raise the cover until the latch engages and the cover
is held in the upright position.
CAUTION: The heating platen and other internal
parts can get extremely hot! Use the tongs when
working near the platen.
4. Lift the heater platen assembly until it catches the
magnetic stop, then look for the jammed strip at the
bottom of the binder. It could be in the feed slot or
stuck to the platen.
5. Remove the strip using the tongs. (figure 33)
6. If there's any glue on the platen, this is a good time to
clean it (see page 34).
7.
When finished, pull the heater platen assembly towards
you to disengage from the magnet and gently place it in its
original position.
8. Close the machine by releasing the left rear lever and
pressing down on both sides of the cover until the
latch clicks and locks in position.
FASTBACK MODEL 20 USER'S MANUAL 208714 - REVB00
39
Tabla de contenido
