PLAYKIN QUAD RACER Manual Del Usuario página 39

INSTALL THE REAR AXLE
1. Press and lock the rear suspension pivot (K) into position as shown in the figure.
2. Place the rear axle (A) through the hole (keep the same length on both sides).
ATTACH THE FRONT AND REAR WHEELS
Install the front wheel:
×
1. Place an M12(S1) washer on both sides of the front axle (G).
2. Install the front wheel (B) on the front axle (G).
3. Place two M12 washers (S1) on the ends of the front wheels (B) and secure with the pin (S4).
Install the rear wheel:
×
4. Place the rear wheels (C) on both sides of the rear axle (A).
5. Install the C (rear wheel) on both sides of the A (rear axle). (Note: the convex side of the C (rear
wheel) is on the inside).
6. Place two M12 washers (S1) on the ends of the rear wheels (C) and secure with the pin (S4).
Press and lock the hubcaps into position.
×
S4
S4
D
D
S1
S4
S4
S1
S1
D
D
A
A
C
C
S1
B
B
S1
S1
K
K
C
C
A
A
S1 S1
G
G
39
S4
S4
D
D
S1
S1
B
B
S4
S4
S1 S1
D
D
EN